Before exploring the specific defects are working in color, there are some common causes of failure paint should always be observed. Each time that the problems in a coating of paint, to avoid the rapid general overview of the causes too much confusion in the future. Could the first improper connections around the house, the moisture can penetrate into the openings. Then try to touch the ground moist wood, which would cause the wall from moisture.
Problems may arise from the construction ofFloor care with little or no ventilation, especially if it is not practical. Painting on wet surfaces are almost always lead to failure. Paint of poor quality or improperly mixed paints and / or used, it becomes problematic. Additionally, primers must be given sufficient time to dry, otherwise it will cause errors.
Finally, with pain, which forms a hard and brittle films a negative effect on the final product. After a good painting, without flaws or imperfectionsparticularly important in the bathroom, where it can steam on glass shower doors or shower curtain in a scroll and destroy the final sloppy.
A wardrobe is a defect due to a primer that is too soft. It takes the form of countless divisions in the area, not to renew through them to the wood. Sanding and dusting is usually sufficient preparation for new paint. A lot of time to dry between layers and a good mix will also help to avoid such conditions.Alligatoring, another fault is to look like. Only the surface of the paint is concerned, but more.
The separation of the ink film is bigger, and harder to reshape the surface. This defect is due to a soft undercoat and insufficient drying his hands, too much oil or oil contaminated or diluent, which does not allow that caused the color on the hard, dry. To remedy alligatoring you must remove the paint with a torch and scraper.
Paintingalligatored surfaces will result in a bad area and possible rupture of the new paint. This deficiency is particularly attractive in bathroom design bathroom vanities are made of wood painted. To focus more on the bathroom vanities and cabinets for guests, because otherwise you can not see to do, while using the toilet for a few seconds.
Scaling is the end result of cracking. Cracking is the separation of the ink film to the wood. The moisture penetrates behind the paintFilms and it answers. This defect is a difficult color or inelastic, can not expand with the wood under temperature fluctuations. Poor or improper color mixtures are their causes. The only remedy is to scrape or burn off any loose paint and repaint in accordance with the formula for new wood outside.
This laborious process could prove even more difficult when you paint from a non-wood surfaces, such as a bathtub drain, door handle, a metal chair, a sink to remove bath tub, porcelain,WC, Postfach, iron or cast iron bathtub boat. Bubble formation is accompanied by peeling. The first color is released from the surface and appear as bubbles. Crack does not always blow, but when there are cracks, creases on the color, so the surface.
The most common cause of this defect is moisture behind the paint. This can be done without painting until the surface to dry completely to avoid. The remedy is the same for the coating of scale. Columns of the portico, the bladder after each coatingmoisture contained within the column. This can be from small holes in the top and bottom to be overcome to allow for ventilation.
Nodes is caused by bleeding through the paint in oil-dissolving substances in the nodes, making it bleed. This can be avoided by the nodes shellacking. In persistent cases, the addition of aluminum powder to remove the shellac for the inconvenience. Discoloration is resolved by substances in the wood has caused and contributed to the surface. With dryingBefore painting the wood is to prevent it.
0 comments:
Post a Comment